KORTECHS KS-1 quickshifter installation



The sensor is simply and quickly installed on your original linking bar. However, this bar  should be round or machined at Ø12mm at one end. Fasten the electronic box where you want on the karting with the self aggripant tape delivered. Connect the grounding wire to the ignition, AS SIMPLE AS THAT !


The kit is composed of all necessary components for the installation and use of the KORTECHS KS-1 quickshifter.

 

It remains for you to equip yourself with the following:

 

  • a metal saw to cut the bar at length
  • a Ø5 mm dril and a driller
  • a hammer to install the pin
  • a set of wrenches to tighten and set up

KORTECHS KZ karting Quickshifter
KS-1 KARTING QUICKSHIFTER